Integrations examples

Choose the diagram that matches your coordinate source: a GPS module or a telemetry output. Arrows show the direction of data flow. A dot marks a branch, and all GND points share a common ground. Check the connector pinout, signal levels and supply voltage for your hardware before wiring it.

Sharing a GPS module on a UART

Connect the beacon’s data input to the GPS module’s TX line. This line already feeds the flight controller’s RX input.

Sharing a GPS module on a UART — Connect the beacon’s data input to the GPS module’s TX line. This line already feeds the flight controller’s RX input.

Example for iNav, Betaflight and Cleanflight.

Connecting to a controller with external GPS

Keep the GPS module connected to the controller. Take the beacon signal from the documented GPS data line in the cable.

Connecting to a controller with external GPS — Keep the GPS module connected to the controller. Take the beacon signal from the documented GPS data line in the cable.

Example for Naza with external GPS.

Connecting through a separate GPS interface

Here the GPS receiver plugs into a separate interface module. The beacon takes its signal from the cable between the receiver and the GPS port on that module.

Connecting through a separate GPS interface — Here the GPS receiver plugs into a separate interface module. The beacon takes its signal from the cable between the receiver and the GPS port on that module.

Example for Naza with a PMU.

Tapping the GPS input at the flight controller

At the controller’s GPS connector, identify the pin that carries incoming data from the attached GPS receiver. Connect that line and ground to the beacon.

Tapping the GPS input at the flight controller — At the controller’s GPS connector, identify the pin that carries incoming data from the attached GPS receiver. Connect that line and ground to the beacon.

Example for the APM GPS connector.

Sharing a telemetry output with an on-screen display

The controller’s TX output already feeds the display’s serial input. Connect the beacon’s input to that same line. The telemetry stream must include position data.

Sharing a telemetry output with an on-screen display — The controller’s TX output already feeds the display’s serial input. Connect the beacon’s input to that same line. The telemetry stream must include position data.

Example for APM with MAVLink telemetry.

Sharing a GPS receiver with a telemetry logger

The logger and beacon both read the same GPS receiver. Take the signal from the line that feeds the logger’s GPS input.

Sharing a GPS receiver with a telemetry logger — The logger and beacon both read the same GPS receiver. Take the signal from the line that feeds the logger’s GPS input.

Example for EagleTree GPS.

Connecting to a serial telemetry output

Connect the telemetry system’s TX output to the beacon’s data input and join their grounds. The dashed line shows optional power. Use the 5 V output only if the beacon has a matching power input.

Connecting to a serial telemetry output — Connect the telemetry system’s TX output to the beacon’s data input and join their grounds. The dashed line shows optional power. Use the 5 V output only if the beacon has a matching power input.

Example for EagleTree Vector using OpenTelemetry.

Installation examples for consumer drones


Third-party product and company names are trademarks of their respective owners and are used solely to describe technical compatibility. tBeacon is not affiliated with, endorsed by, or sponsored by those owners.