Your shopping cart is empty!
Русская версия
Your tBeacon has arrived. Let’s introduce it to your search device while the model is still on the bench, rather than somewhere in the nettles. We’ll connect the battery, make a test call and check the position. Checking the radio link takes a few minutes; the first GPS fix may take longer.
Check the model name on the board or packaging. Inspect the beacon, battery and antenna. Connect the battery with the correct polarity and keep its contacts from shorting.
The beacon needs its own battery connected, including when configuring it from a computer. Follow the model’s instructions for any soldering, heat-shrink or protective coating, rather than a photo of a similar-looking board.
Choose your search device to see its complete set of steps below.
Connecting your phone to Findy is the first step. Now let’s check that the beacon itself answers.
For a beacon with built-in GPS, go outside with a clear view of the sky. Keep the GPS antenna clear of the battery, metal and carbon fibre, and allow time for a fix. For Lime, check that the external GPS or flight controller is sending position data to the beacon. Then call it again with Findy.
A marker left on the map from an earlier session proves neither a working link nor a GPS fix. You need a new beacon reply and a check of its data.
For Onyx/Onyx2 and Lime, disconnect external power and hold the beacon’s button for about 5 seconds, until it switches off. For other models, check their instructions. Turn the beacon on again and repeat the single call with Findy. If you plan to use Findy’s shutdown command, test it close to the beacon beforehand. Switch the beacon back on before flying.
Ready to fly: the beacon is on, Findy receives a new reply with it fitted to the model, and any GPS position you’re relying on has been checked. A minute on the ground usually beats an evening in wet grass.
If the test fails, find the cause before flying. Your first real search is a poor time to discover how the settings work.
The calling tone is audio sent by the radio, not its operating frequency. “1750” and “433.075” belong in different settings.
For a beacon with built-in GPS, go outside with a clear view of the sky. Keep the GPS antenna clear of the battery, metal and carbon fibre, and allow time for a fix. For Lime, check that the external GPS or flight controller is sending position data to the beacon. Then call again.
Write down both coordinates and enter them into a navigation app using the same format as the beacon. Check the signs and the order of latitude and longitude, then make sure the position matches your test site.
For Onyx/Onyx2 and Lime, disconnect external power and hold the beacon’s button for about 5 seconds, until it switches off. For other models, check their instructions. Turn the beacon on again and call it with the radio. Test contactless shutdown beforehand using your model’s instructions; availability and settings vary by version. Switch the beacon back on before flying.
Ready to fly: the beacon is on, answers a radio call when fitted to the model, and any GPS position you’re relying on has been checked. A minute on the ground usually beats an evening in wet grass.
tBeacon documentation and manual
Frequently Asked Questions
tBeacon Lime radio beacon
$59.90
tBeacon Onyx 2 radio beacon with embedded GPS
$75.22